-
by Angel Medina
Hey all,
This guide was made for people who are confused as to how the rivets will sit in the PCB. We tried to make the design fairly user friendly...
-
by Angel Medina
For the Freja65, we decided to make them friction fitted with plumbi that go on the underside of the PCB that will prevent them from bottoming out....
-
by Angel Medina
Hello all! Sorry there have not been many updates on our blog posts, most of our updates can either be found on our Instagram or through our Discor...
-
by Angel Medina
Hey everyone, Angel from Helheim Designs bringing you an unexpected update for our Baldr60 and all four of our Deskmats. Due to a combination of bo...
-
by Angel Medina
Hello all!
It's been a while since we finished our pre orders for Baldr60, so we decided it's time to give an update as to where we are with the ca...
-
by Angel Medina
Hey all, Angel from Helheim Designs bringing some new information we think all current and new customers will enjoy reading. As the people followin...
-
by Angel Medina
Hello all, Angel here to address a very common question we have seen over the last couple months while promoting our case both on subreddits, and i...
-
by Angel Medina
Hello all, it has been a couple of months that we have been working behind the scenes getting paperwork and drafting other possible projects to bri...
-
by Angel Medina
Hello all, it's been a while since we've last updated, so we're going to give you a little breakdown of what has been going on behind the scenes. D...
Use left/right arrows to navigate the slideshow or swipe left/right if using a mobile device